Datalogic Controller SC6000 Manuale Utente Scaricare il pdf (Pagina 20)

SC6000 HOST MODE PROGRAMMING

3.5 SAVE AND RESTORE COMMANDS

The 'Data Storage' programming command must have the following format:

E<space>MODE<CR><LF>

Where:

 E:

Data Storage command.

 MODE:

Data Storage mode. The possible values are:

V = Storage in temporary (volatile) memory only.

P = Storage in temporary and permanent memory.

If the programming is correct, the device updates the configuration and confirms with the

following message:

Y<space>MODE<CR><LF>

Where:

 MODE:

Data Storage mode.

CAUTION

Restart of the device is now forced. If no disconnection commands are sent

within a minimum timeout of 300 ms, the device will transmit the Self

Disconnection message (refer to the Paragraph 2.3).

If programming contents are wrong (i.e. a typing error in the file) or due to a transmission

error, the device replies with the following message and programming data will not be

updated in this case:

N<space>ERRCODE<CR><LF>

Where:

 ERRCODE:

Error Code (signed DEC value).

For information on Error Codes see the "Error Codes Table" in the Appendix.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 79 80

Nessun commento

Datalogic Controller SC6000 Manuale Utente Pagina 20